9 - 3
Back Panel
Auxiliary Battery Well
The auxiliary battery well charges an additional Li-ion battery pack independently of the
terminal well. This feature ensures that you can always have a fully-charged battery for your
terminal; see Charging a Spare Battery Pack on page 9-4.
DC Power Jack
Connect the power cable to this power jack; see Power on page 9-5.
Handle Saddle
The curve on the back wall of the terminal well accommodates the pistol-grip handle when the
terminal is seated in the well.
RS-232 Port
For RS-232 data communication, use the 9-pin, RS-232 cable from Honeywell to connect this
port to a peripheral device. For more information, see RS-232 Serial Connector on page 9-6.
USB Port
This USB Port is full-speed, 2.0 compliant, and requires ActiveSync 4.5 or higher. Using a USB
cable, you can connect the base to a USB-compliant device. When the base is connected to
that device, the terminal is connected to the device when seated in the terminal well.
The base acts as a USB device by interfacing the USB signals of the terminal to the USB
signals of the host workstation; see ActiveSync Communication on page 9-8.
Auxiliary
Battery
Well
DC Power
Jack
RS-232 Port USB Port
Handle Saddle
To Next Page
Loading...
