14 - 6
Mounting
The charger should be on a dry, stable surface and can be mounted on a flat, horizontal surface such as
a desktop or workbench, or a flat, vertical surface such as a wall.
When choosing a location, always bear in mind that
• the mounting location must allow users easy access to power switch and power connector.
• the charger should be oriented so that users can easily insert and remove battery packs and read the
labels, especially for the Battery Analyzer.
Installation Hardware
The DIN rail slot (7.5 X 35 mm) on the bottom panel to enables secure mounting to a desk or a wall.
Screw: 3/16 in. dia x 5/8 in. long pan head screw
Washer: 1/2 in. OD x 7/32 in. ID x 3/64 in. thick
Nut: 3/16 in. dia
Desk Mounting
Slide the DIN rail slot into the bottom panel.
Then, using the appropriate nuts and bolts listed above, secure the DIN rail to the desk or wall.
To Next Page
Loading...
