28
Note that with this keyfob arming is immediate. Only arm the system once you are
outside the area to be protected.
To arm the Total or Partial set:
Press the Total or Partial arm button.
The associated light blinks during communication with the panel and remains lit for
3 seconds to confirm that the system is armed.
The arming tone is emitted by the panel siren.
6
ARMING OF THE TOTAL OR PARTIAL SET
How to use the keyfob with 3 LEDs
The keyfob can be used to arm or disarm your security system, to trigger an audible
or silent alert, as well as to control electrical equipment from a distance (see Remote
Control of Appliances, page 29).
This keyfob is optional, but 1 to 10 keyfobs of this type may be included with this
system. It comes with a carrying strap for attachment to a keyring.
ARMING OF THE ANNEX SET
If the system is set up with an Annex Set:
To arm the Annex Set: press and simultaneously.
To disarm, press and simultaneously.
If the system diagnoses a fault on arming, you cannot set the alarm. Faults include system
faults, tampering and triggering of detectors.
►
A tone indicating a fault is emitted by the panel siren after the arming request,
instead of the arming tone.
Check that all doors and windows equipped with detectors are closed.
You can override prevention of arming by requesting arming a second time within
two minutes of the first request. This will bypass all faults.
The arming process restarts.
ARMING WITH FAULT
To Next Page
Loading...
