Honeywell Notifier DVC - User Manual

Configuration, Programming and Operation Manual for
Mass Notification Systems
Document LS10063-000NF-E Rev: E
06/26/2019 ECN: 18-0305

Honeywell Notifier DVC Specifications

General

Type	Digital Voice Command
Operating Temperature	32°F to 120°F (0°C to 49°C)
Compatibility	Notifier Fire Alarm Control Panels
Operating Voltage	24 VDC nominal
Current Draw	Standby: 120 mA, Alarm: 250 mA
Humidity Range	10% to 93% non-condensing
LED Indicators	Power
Relay Contacts	2 Form C relays
Certifications	FM, CSFM, MEA

Summary

Section 2: Configurations

2.1 Autonomous Control Unit (ACU)

Describes the primary local control unit for a mass notification system.

2.2 Local Operating Console (LOC)

Details the console used by authorized personnel to initiate messages and signaling.

2.3 Central Control Station (CCS)

Explains the system component for emergency communication and control.

2.4 MN Alarm Indicator

2.5 Inputs

2.6 Outputs

Section 3: Programming

3.2 Programming Steps

3.3.1 DCC Participation

3.3.2 Mass Notification Control Settings for the DVC

Explains how to configure MN control settings on the DVC.

3.3.3 Set the Priority

Guides on setting the priority between fire and mass notification events.

3.3.4 MN Mapping

Defines how MN mapping determines fire suppression based on MN alarm status.

3.3.5 Type IDs

3.3.6 Special Function Zones

3.3.7 MN Active Tone

3.3.8 Fire Active Tone

3.3.11 MN Annunciator Programming

Section 4: Operation

4.1 Mass Notification Events

Details how MN events signal locally and over the network.

4.2 Performing a System Reset

Explains the procedure for resetting the system with fire and MN events present.

4.3 Output Event Suppression

Lists factors for achieving desired event suppression in MN systems.

4.4 Mass Notification Control Operation

4.5 Paging

4.6 Drill Operation