Figure 2-8
18. Remove the MMI flat cable plastic protection.
19. Remove the 3 flat cable clips. (See ref. A, Figure 2-9)
20. Remove the ink ribbon carriage stop (see ref. B standoff, Figure 2-9). Unscrew the fixing screw.
21. Remove the reinforcing bar (see ref. C, Figure 2-9) by unscrewing the 2 screws.
A
B
C
Figure 2-9
22. Unscrew the 3 fixing screws from the PCMCIA sub-assembly. (See Figure 2-10).
Figure 2-10
23. Remove the MMI with 2 screws (see B in Figure 2-11)
24. Put in place the PCMCIA sub-assembly on the left hand printer chassis side plate.
(See Figure 2-11)
25. Fix the PCMCIA sub-assembly with the 3 screws M3. (See ref. A, Figure 2-11) one from the
carriage stop.
WARNING: The 3 PCMCIA board fixing holes may have a wrong diameter (2.2 mm) but only on
the very first 180 mm units.
In this case, you have to enlarge them to 3+ 0.5/0 mm.
- Ins
ert fully your memory card (not supplied) in the card guides.
- Fix the memory card guides with the 2 screws M2. (See ref. B,
Figure 2-11) by reinstalling the
MMI.
8 PCMCIA Option Manual
To Next Page
Loading...
