PCMCIA Option Manual 13
3. OPERATION
3.1 Overview
3.1.1 PCMCIA card standard compatibility
The embeded PCMCIA driver supports all ATA flas
h card devices with a size from 2Mb up to 75Mb and
is compatible with the PC card format (type II).
The write-protected signal available
on these cards is not tested and not used because of a lack of
standard rules.
3.1.2 PCMCIA card handling
If your recorder is equipped with the PCMCIA option
board, you can use a memory card to store the
recorder information.
For this, proceed as indicated in the following figure to introduce the memory card:
Figure 3-1: Card loading in the 180mm or 250mm recorder
Note: The recorder will automatically detect the card presence.
The recorder indicates the writing status by lighting a led located un
der the display
(see Figure 3-2).
This led must be off when removing the memory card (this can be done with the remove or stop
function
), if not, some data may be lost.
To remove the memory card press the button located above it.
To Next Page
Loading...
