2. INSTALLATION
2.1 Installing the PCMCIA option board
Î WARNING: Please use an antistatic ground strap to av
oid possible electrostatic damage to the
printed circuit boards.
1. Turn off the power to isolate the recorder from the main supply.
2. Open the recorder door and remove the chart cassette from the chassis.
3. Turn OFF the switch. (See Figure 2-1)
Recorder's main power switch located behind the chart cassette
Figure 2-1
4. Remove the cover from the power supply terminal block. (See ref. E, Figure 2-15)
5. Disconnect the main supply from the power supply terminal block.
6. Unscrew the 3 fixing screws from the rear cover. (See ref. A, Figure 2-2)
7. Remove the rear cover. (See ref. B & C, Figure 2-2)
PCMCIA Option Manual 3
To Next Page
Loading...
