30. Put in place the MMI flat cable on the PCMCIA cover.
31. Fix it with the 2 flat cable clips supplied (with foam). (See ref. A, Figure 2-13)
A
B
C
Figure 2-13
32. Ensure the MMI can open properly.
- Open the MMI fully.
- Remove the protection of the double-side adhesive tape located on the PCMCIA cover.
- Fix the MMI flat cable.
- Put in place the MMI flat cable at the rear of the PCMCIA cover. (See ref. C,
Figure 2-13)
33. Put in place the third MMI flat cable clip (not supplied) at the rear of the printer chassis.
(See ref. B, Figure 2-13).
34. Connect the MMI flat cable to the CPU Board (see Figure 2-14). Ensure the connectors are
locat
ed correctly.
10 PCMCIA Option Manual
To Next Page
Loading...
