Figure 2-14
35. Replace the CPU board protection cover.
Replace the 3 fixing screws.
36. Replace the slot covers.
37. Replace the power supply. Replace the 2 rightest fixing screws.
38. Slide the recorder chassis back into the outer case.
39. Replace the 4 fixing screws (M4) with the Torx key T20. (See ref. B, Figure 2-4)
40. Replace all terminal blocks and grommets.
41. Replace the rear cover. Replace the 3 fixing screws. (See ref. A, Figure 2-2)
42. Reconnect the main supply to the power supply terminal block.
43. Replace the power supply terminal block cover. (See ref. E, Figure 2-15)
44. Turn ON the switch. (See Figure 2-1).
45. Replace the chart cassette.
46. Switch ON the main supply.
47. Upgrade your recorder firmware if the revision is lower than 001AK. (See CK 214).
PCMCIA Option Manual 11
To Next Page
Loading...
