Honeywell ERM5220R - Page 51

11 33-00135EFS—07
Monte el ERM
9. Utilice dos tornillos y tarugos de pared para fijar el ERM a la
pared exterior cerca del compresor. La ubicación debe estar por
lo menos a 3 pies (91 cm) por encima del suelo y orientada
con las dos salidas de cable hacia abajo. Vea las Figs. 11 y 12.
10. Fije la cubierta y asegúrela con el tornillo inferior (Fig. 13).
Fig. 11. Orientación de montaje.
MSCR35665
TORNILLOS DE
MONTAJE
CORRECTA
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS
Flashing: Device Connecting
Green: Device Connected
Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y2
T
O/B
T
D
L
S1
S1
INCORRECTAINCORRECTA
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS Flashing: Device Connecting Green: Device Connected Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y2
T
O/B
T
D
L
S1
S1
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS
Flashing: Device Connecting
Green: Device Connected
Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y2
T
O/B
T
D
L
S1
S1
33-00135EFS_D.book Page 11 Friday, September 8, 2017 1:59 PM