Honeywell Analytics Fire Sentry Corporation
6349-001
Revision 1.2, Release Date: 15 February 2013 Page 11 of 16
8. UNIVERSAL COMMANDS
Command #3 returns PV, units, and Loop Current. The first (PV) and the last (Loop Current)
variables are same.
Command #14 contains serial number of the device (3 bytes), followed by measurement units
(1 byte) and 3 floating point variables for max, min, and span loop current in mA.
9. COMMON-PRACTICE COMMANDS
9.1 Supported Commands
The following common-practice commands are implemented:
38 Reset "Configuration Changed" Flag
48 Read Additional Device Status
Command #48 returns 2 bytes of data.
9.2 Burst Mode
This Field Device does not support Burst Mode.
9.3 Catch Device Variable
This Field Device does not support Catch Device Variable.
10. DEVICE-SPECIFIC COMMANDS
The Field Device does not support any device-specific commands.
To Next Page
Loading...
Need help?
General
