Honeywell FS24X User Guide

Honeywell Analytics Fire Sentry Corporation
6349-001
Revision 1.2, Release Date: 15 February 2013 Page 14 of 16
12.5 Busy and Delayed-Response
The transmitter may respond with "busy" status if a further command is received while self-
test is underway.
Delayed-response is not used.
12.6 Long Messages
The largest data field used is in the response to Command 21: 34 bytes including the two
status bytes.
12.7 Non-Volatile Memory
EEPROM is used to hold the device’s configuration parameters. New data is written to this
memory immediately on execution of a write command.
12.8 Modes
Fixed current mode is implemented, using Loop current mode (Enable – Point to Point /
Disable- Multi-drop). This mode is not cleared by power loss or reset.
12.9 Write Protection
Write-protection is not supported.
12.10 Damping
User controllable Damping is not supported.

Honeywell FS24X Specifications

General

Brand	Honeywell
Model	FS24X
Category	Security Sensors
Language	English