Honeywell Galaxy Flex - Setting the System (Full Set); Full System Setting Procedure; Cancelling Full Set During Exit Time

9
Set the system – full set
To set the system, make sure all doors are closed and windows are secure. The
system cannot be set if there has previously been an alarm that has not been reset.
To set the entire system:
1. Do one of the following:
 Keypad: Enter your PIN code, and then press A .
 Keyfob: Press (the top button).
 Prox tag or card: Hold the tag or card in front of the prox symbol/ MAX
4
reader for three seconds.
A 30 second exit timer begins and a constant tone is sounded.
2. Leave by the agreed exit route and close the door.
When the exit timer expires, there is a five second settling period, followed by two
beeps to confirm setting completion.
To cancel set during the exit time:
 Do one of the following:
 Keypad: Press esc .
 Keyfob: Press (the second button down).
 Prox tag or card: Hold the tag or card in front of the prox symbol/ MAX
4
reader.
Open Zone 1044
FULL SET 30
■■■■■■■■□□□□□□□□