www.honeywell.com/security
22 | Performance Series IP Camera User Guide
Configuring the Live Interface
You can configure the Live interface using the toolbar located in the lower left corner of the
screen (Figure 2-4).
Figure 2-4 Live Interface Configuration Toolbar
Table 2-1 Live Interface Configuration Tools
Image Adjustment Opens the Image Adjustment panel.
Drag the sliders to adjust the image
brightness, contrast, hue, and
saturation. Click the – and + signs to
make fine adjustments.
To restore the settings to their
default values, click Reset.
Note These settings only apply to
the client end. To change the
settings at the camera end, go to Setup > Camera >
Conditions.
Original Size Displays video in its original size (determined by the stream
resolution).
Full Screen Displays video in full-screen mode. Double-click the mouse
or press Esc to exit full-screen mode.
Width:Height Ratio Displays video in its original size (Original) or fitted to your
screen (Adaptive). Click to toggle between the two.
Fluency Sets the video fluency level (Realtime, Normal, Fluency).
Select a fluency level based on your network connection. For
example, if your connection is slow, selecting Fluency will
prioritize smoothness over image quality.
Zoom and Focus Opens the Zoom and Focus panel.
Drag the sliders to adjust the zoom
and focus settings. Click the – and +
signs to make fine adjustments. The
Step number determines the
magnitude of the adjustment.
To set the focus automatically, click
Auto Focus. To restore the default
zoom and focus settings, click
Restore All. To focus on a specific
region, click Regional Focus, and
then drag your mouse over the area
in the video window.
To Next Page
Loading...
