Honeywell HCC80R User Manual

HCE80(R) / HCC80(R)
Mounting and operation
Montage en bedrijf

Honeywell HCC80R Specifications

General

Brand	Honeywell
Model	HCC80R
Category	Controller
Language	English

Summary

Introduction

System overview

Overview of the intelligent system for individual room temperature control.

Function overview

Mounting and installation

Creating a zoning plan

Process for defining temperature zones and allocating rooms and actuators.

Safety instructions

Critical safety warnings regarding electrical shock, humidity, and electrostatic discharge.

Installing the underfloor heating controller

Instructions for wall and DIN rail mounting of the underfloor heating controller.

Settings at the underfloor heating controller

Procedures for opening the housing and setting thermal actuator types.

Cabling

Permissible cable types, lengths, and connection procedures for power and antenna.

Cabling – continued

Connecting the thermal actuators

Step-by-step instructions for wiring and connecting thermal actuators to zones.

Connecting a pump (230 V AC)

Commissioning

Process for assigning setpoint generators/sensors and time programs to temperature zones.

Connecting devices (binding)

Binding room setpoint generators/sensors with the evohome controller

Steps to connect room sensors/generators to the evohome controller for zone control.

Commissiong and binding the evohome controller

Binding a room setpoint generator/sensor (HCW82 or HCF82)

Binding a room thermostat (DTS92)

Binding the underfloor heating controller with the evohome controller

Binding the room device CM927 with the underfloor heating controller

Instructions for setting CM927 to binding mode and assigning it to zones.

Binding the underfloor heating controller without time program

Binding the room thermostat DTS92 with the underfloor heating controller

Binding room setpoint generators/sensors HCW82/HCF82 with the underfloor heating controller

Cancelling the assignment of zones (rooms)

Checking the installation

Checking the configuration

Test the radio communication

Help with problems

Changing the fuse

Restoring the factory settings at the underfloor heating controller

Procedure to reset the controller to its original factory default configuration.

Fault displays

Errors and elimination

A table detailing specific problems, their causes, and proposed solutions for troubleshooting.