HLS PS25 & HLS PS50 User Manual
MN-DT-1305I_B 13
OUTPUT 1 FAULT Led
Indicates that the output 1 is not powered.
OUTPUT 2 FAULT Led
Indicates that the output 2 is not powered.
EARTH FAULT Led
Indicates an Earth Fault if one of t he wirings (+) o r (-) is lin ked to
earth.
If J3 is not connected, there will not be earth fault supervision.
Earth fault solution: Ma ke su re t hat there are n o links bet ween
Earth and Output 1 and 2 (+) y (-).
OVERLOAD Led
Indicates that the equipment exceeds the maximum current, 5 A.
A momentary peak voltage may be provide d by disa bling the
battery load current in ca se of al arm by usin g the IN ALARM
connection, which switches the battery current of 3 00 or 6 00mA to
the outputs.
SYSTEM FAULT Led
Indicates that the Power Supply microprocessor is not operating
correctly.
To Next Page
Loading...
