Honeywell PS-HL-138 BM Series User Manual

1
PAK200467-HW_01A March 2020 2020 Honeywell Security
PS-HL-138xxBM Series : 13.8V dc Switch Mode Power Supplies
with Standby battery charging, fault monitoring & remote fault signalling
PS-HL-13805BM-4OP (5A / 4 x Fused Outputs) PS-HL-13810BM-8OP (10A / 8 x Fused Outputs)
FEATURES
High efficiency cost effective power supply range ideal for Access Control applications.
Featuring a regulated 13.8V dc output supplying continuous full rated current to load
and a universal mains voltage input. Standby battery recharging is achieved within 24h
for an 18Ah battery. Maximum battery life is assured using deep discharge protection
to prevent premature battery failure when operating in standby mode for extended
periods. Two sets of volt free contacts are provided to signal (i) loss of mains and (ii)
battery and loss of output faults. The 5A model is provided with 4 x 1.25A Fused
Outputs whilst the 10A model is provided with 8 x 1.25A Fused Outputs.
• Continuous full rated current to load
• 18Ah Standby battery recharged to 80% within 24 hours
• Universal mains input voltage 90-264V ac
• High efficiency electronics for reduced running costs and lower operating
temperatures
• Installer safe design with all high voltage electronics fully shrouded
• Full electronic short circuit and overload protection on load output under mains
operation
• Mains transient protection circuit
• Lid and removal from wall tamper detection
• Green Mains present LED
• Red Fault LED
• Volt free contact signalling mains failure
• Volt free contact signalling output and battery faults
• Individually Fused Outputs
Honeywell Middle East
Emaar business Park, Tel: +971 4 450 5800
UAE : www.honeywell.com

Honeywell PS-HL-138 BM Series Specifications

General

Brand	Honeywell
Model	PS-HL-138 BM Series
Category	Power Supply
Language	English

Summary

Product Features

Product Specification

Input Specification

Details on mains voltage, frequency, and input current requirements for the power supply unit.

Output Specification

Specifies voltage, load current, ripple, and overload protection for the power supply outputs.

Standby Battery

Information on battery type, capacity, and charging fuse protection for standby operation.

Mechanical

Physical dimensions, enclosure size, and weight specifications for different models.

Environmental

Operating and storage temperature and humidity ranges for the power supply unit.

Local Indicators

MAINS LED (Green)

Indicates the status of the mains power supply, showing when it is present.

FAULT LED (Red)

Signals fault conditions such as mains loss, battery issues, or output faults via flashing.

Connections and Signalling

CONNECTIONS

Details the terminal connections for load outputs, battery, and fault signalling contacts.

SIGNALLING OUTPUTS

Describes the volt-free contacts for general faults, mains failure, and lid tamper detection.

Installation and Commissioning

Mounting

Instructions for securely mounting the unit and routing cables, ensuring proper clearance.

Mains Power Up

Steps for connecting and applying mains power, including checks on LEDs and outputs.

Load Output

Guidance on connecting load cables, applying power, and verifying correct operation.

Standby Battery

Procedures for connecting the standby battery, emphasizing correct polarity.

Operation and Maintenance

OPERATING INSTRUCTIONS

Notes that the unit is for service personnel only and explains LED behaviour during operation and faults.

PREVENTATIVE MAINTENANCE

States no regular maintenance is needed, but recommends periodic testing and battery checks.

Explanation of Symbols