Honeywell PS-HL-138 BM Series - Connections and Signalling; CONNECTIONS; SIGNALLING OUTPUTS

4
PAK200467-HW_01A March 2020 2020 Honeywell Security
CONNECTIONS
+LOAD 1,2,3,4
+ve voltage output to load equipment
-LOAD 1,2,3,4
-ve voltage output to load equipment
EPS Fault
Voltfree contacts for loss of mains indication
GEN Fault
Voltfree contacts for general faults (see signalling outputs)
+BATT
-BATT
+ve (Red lead) connection to standby battery
-ve (Black lead) connection to standby battery
SIGNALLING OUTPUTS
GEN Fault (general)
Open when battery disconnected, *output fuse fail,
battery fuse fail or output short circuit. (*Applies only to
O/P 1 of multiple fused units).
Rating: 0.1A @ 60V dc N/O volt free contact.
EPS Fault (mains)
Open when loss of mains for more than 10s.
Rating: 0.1A @ 60V dc N/O volt free contact.
Lid Tamper
Note: Contact open in when lid opened by normal
means or unit is removed from mounted surface
Rating: 3A @ 125V ac N/O volt free contact.