Need help?Do you have a question about the Honeywell Fire-Lite FL-PS10 and is the answer not in the manual?
Discusses limitations of smoke detectors, including placement and environmental factors.
Covers limitations and considerations for IP and cellular alarm signaling communications.
Lists earth fault resistance detection and open/short trip values for NAC circuits.
Explains the function and operation of the SW1 ground fault detection switch.
Outlines the step-by-step procedure for starting up the FL-PS power supply.
Provides instructions and dimensions for mounting the FL-PS backbox securely.
Details wiring configurations for Notification Appliance Circuits (NACs), including Class B and Class A.
Outlines wiring separation requirements for power-limited and non-power-limited circuits.
Illustrates connecting the FL-PS in slave mode to a master FACP for synchronized output.
Shows connecting the FL-PS in master mode to an FACP with non-synchronized output.
Explains how to cascade up to four FL-PS power supplies for extended NAC coverage.
Describes methods for monitoring ground faults in Canadian applications with cascading units.
Details global control options for the FL-PS using DIP switch S1 settings.
Explains debounce/dejitter settings for input signals to prevent false triggers.
Details DIP switch settings (S2-S8) for controlling individual output circuits.
Describes programming individual NAC circuits based on command input assignments.
Sets the FL-PS for master or slave synchronization of notification appliances.
Configures master mode for selective silence of horn sounders while strobes remain active.
General| Frequency | 60 Hz |
|---|---|
| Output Voltage | 24 VDC |
| Output Current | 10 A |
| Battery Charging | Yes |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Input Voltage | 120 VAC |
| Dimensions | 12.5 in x 10.5 in x 3.5 in (318 mm x 267 mm x 89 mm) |
| Relative Humidity | non-condensing |
| Number of Outputs | 2 |
To Next Page