Honeywell PS-HL-138 BM Series - Product Specification; Input Specification; Output Specification; Standby Battery

2
PAK200467-HW_01A March 2020 2020 Honeywell Security
COMPLIANCE
This power supply unit meets the essential requirements of the following European
Directives:
Low Voltage 2014/35/EU EMC 2014/30/EU WEEE 2012/19/EU RoHS
2011/65/EU
SPECIFICATION
Input Specification
Voltage (rated)
100-240V ac
Voltage (operating)
90-264V ac
Frequency
50-60Hz
Max current
See Model Specification Table overleaf
Mains Input Fuse
See Model Specification Table overleaf
Max standby Power
See Model Specification Table overleaf
Output Specification
Voltage
13.5 – 14.2V dc (13.8V dc nominal) on mains power
10.0 – 12.3V dc on battery standby
Max load current
See Model Specification Table overleaf
Ripple
150 mV pk-pk max
Load output Fuse
See Model Specification Table overleaf
Overload
Electronic shutdown until overload or short circuit
removed (under mains power only)
Standby Battery
Battery Type
12V Valve Regulated Lead Acid
Battery Capacity
See below under enclosure size.
Battery Charging Fuse
protection
See Model Specification Table overleaf
Mechanical
Model
PS-HL-13805BM-4OP
PS-HL-13810BM-8OP
Enclosure Dimensions
w x h x d (mm) [external]
355 x 330 x 80
390 x 410 x 80
Max Battery Capacity
1 x NP17 (18Ah)
2 x NP17 (18Ah)
Weight (kg) excluding
battery
4.3
5.42
Environmental
Temperature
-10 to +40°C (operating) 95% RH non-condensing
-20 to +80°C (storage)