Honeywell HON P095NG-HP - Page 71

Maintenance
UsermanualforHONR100gaspressureregulatorwithHONP095NGpilot  71
Figure Step Description
25
Turnthehousingover.ReplacetheO‐ring
(1)withanew,greasedO‐ring.
26
Puttheupstreampressurestagehousing
backonthesecondpressurestage’s
housing.Makesurethatthediaphragm
unitdoesnotfallout!Tightenthescrews
(1),includingthewashers,inacriss‐cross
sequence.Observethetighteningtorque
informationprovidedinthetablebefore
thissection.
27
Replacethestabilizerseatwithanewone.
Unscrewthenut(1).
28
Insertnew,greasedO‐rings(1,2).Screw
thenutbackon.
29
Screwthestabilizerseat(1)backintothe
housing.