26
Failure Modes
Figure 26: LEDs
Flashing Amber and One Razzberry Tone
This indicates the scanner has experienced a
laser subsystem failure. Return the unit for repair
at an authorized service center.
Flashing Red and Amber and
Two Razzberry Tones
This indicates the scanner has experienced a
motor failure. Return the unit for repair at an
authorized service center.
Continuous Razzberry Tone with
both LEDs off
If, upon power up, the scanner emits a
continuous razzberry tone, then the scanner has
an electronic failure. Return the unit for repair at
an authorized service center.
Three Beeps - on power up
If the scanner beeps 3 times on power up then,
the nonvolatile memory that holds the scanner
configuration has failed. Return the unit for repair
at an authorized service center.
To Next Page
Loading...
