Need help?Do you have a question about the Honeywell HH1800 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | HH1800 |
| Category | Barcode Reader |
| Language | English |
Instructions for connecting the scanner, including USB and RS232 options.
Details configuring the scanner for RS232 serial port communication, including baud rate and data format.
Programs keyboard styles like Caps Lock and Shift Lock.
Configures scanner trigger modes like Manual and Serial.
Allows setting a custom duration for the good read delay.
Improves reading of damaged or poorly printed linear barcodes.
Sets the character used to trigger scanning in Character Activation Mode.
Sets a higher priority for one symbology over others on the same label.
Allows programming the scanner to output data in a specific order.
Explains how to add data before or after scanned barcode data.
Explains how to change the scanner's output by inserting characters into barcode data.
Commands for including characters, numbers, or strings in the output message.
Enables or disables all symbologies for scanning.
Enables or disables the Codabar symbology.
Enables or disables the Code 39 symbology.
Enables or disables the Code 128 symbology.
Enables or disables the UPC-A symbology.
Enables or disables the UPC-E0 symbology.
Enables or disables the EAN/JAN-13 symbology.
Enables or disables the EAN/JAN-8 symbology.
Enables or disables the MSI symbology.
Enables or disables GS1 DataBar Omnidirectional symbology.
Enables or disables the PDF417 symbology.
Enables or disables the QR Code symbology.
Enables or disables the Data Matrix symbology.
Imaging commands take effect for a single capture and revert to defaults.
Command to capture an image, with various modifiers for customization.
Command to transmit the image stored in memory.
Temporarily adds a Code I.D. prefix to all symbologies for testing.
Resets all scanner settings and plug-ins to their original factory defaults.
Details the syntax for menu commands, including prefix, tag, and subtag.
Explains how queries apply to the entire set of commands for a storage table.
Commands to activate and deactivate the scanner using serial triggers.
Describes how the HH1800 scanner connects via USB and RS232.
Addresses threats from viruses, spyware, and worms, and their impact.
Addresses keeping software up-to-date and managing vulnerabilities.
Details mechanical, electrical, and environmental specifications for the HH1800 scanner.
Provides typical performance data for various symbologies, including near/far distances and resolutions.
Pinout details for the USB connection.
Instructions for cleaning the scanner housing and window using soft cloths and mild solutions.
Step-by-step instructions for replacing the scanner's interface cable.
Checks power status and aimer illumination for troubleshooting.
To Next Page