110 HH1800 User Guide
EAN-13 Beginning with 290 Addenda Required
This setting programs the scanner to require a 5 digits addenda only on EAN-13 barcodes that
begin with “290.” The following settings can be programmed:
Require 5 Digit Addenda: All EAN-13 barcodes that begin with “290” must have a 5 digits
addendum. The EAN-13 barcode with the 5 digits addendum is then transmitted as a single,
concatenated barcode. If a 5 digit addendum is not found within the Addenda Timeout
period, the EAN-13 barcode is discarded.
If you are using EAN-13 Beginning with 290 Addenda Required (page 109), this setting will
take precedence.
Don’t Require 5 Digit Addenda: If you have selected Require 5 Digit Addenda, and you want
to disable this feature, scan Don’t Require 5 Digit Addenda. EAN-13 barcodes are
transmitted, depending on the setting you are using for EAN/JAN-13 Addenda Required.
Default = Don’t Require 5 Digit Addenda.
* Don’t Require 5 Digit Addenda
EAN-13 Beginning with 378/379 Addenda Required
This setting programs the scanner to require any combination of a 2 digit addenda or a 5 digit
addenda on EAN-13 barcodes that begin with a “378” or “379.” The following settings can be
programmed:
Require Addenda: All EAN-13 barcodes that begin with a “378” or “379” must have a 2 digit
addenda, a 5 digit addenda, or a combination of these addenda. The EAN- 13 barcode with
the addenda is then transmitted as a single, concatenated barcode. If the required addenda is
not found within the Addenda Timeout period, the EAN-13 barcode is discarded.
Don’t Require Addenda: If you have selected Require Addenda, and you want to disable this
feature, scan Don’t Require Addenda. EAN-13 barcodes are transmitted, depending on the
setting you are using for EAN/JAN-13 Addenda Required.
Default = Don’t Require Addenda.
To Next Page
Loading...
