When an output sequence is Required, all output data must conform to an edited sequence
or the scanner will not transmit the output data to the host device. When it’s On/Not
Required, the scanner will attempt to get the output data to conform to an edited sequence
but, if it cannot, the scanner transmits all output data to the host device as is, or formatted
according to the partial sequence output format (see Partial Sequence on page 46).
When the output sequence is Off, the barcode data is output to the host as the scanner
decodes it. Default = Off.
The scanner may be programmed to either beep or click in response to a good read of each
barcode in an output sequence, or to emit a beep or error tone for a partial sequence. Default
= Good Read Click - Each Code in Sequence and Error Tone - Partial Sequence Output.
To Next Page
Loading...
