Honeywell HH1800 - GS1-128 Message Length; Telepen; Telepen On;Off; Telepen Output

HH1800 User Guide 99
Off
GS1-128 Message Length
Scan the barcodes below to change the message length. Refer to Message Length Description
(page 82) for additional information. Minimum and Maximum lengths = 1-80. Minimum
Default = 1, Maximum Default = 80.
Minimum Message Length
Maximum Message Length
Telepen
<Default All Telepen Settings>
Telepen On/Off
On
* Off
Telepen Output
Using AIM Telepen Output, the scanner reads symbols with start/stop pattern 1 and decodes
them as standard full ASCII (start/stop pattern 1). When Original Telepen Output is selected,
the scanner reads symbols with start/stop pattern 1 and decodes them as compressed
numeric with optional full ASCII (start/stop pattern 2). Default = AIM Telepen Output.