Honeywell HH1800 - GS1 DataBar Omnidirectional; GS1 DataBar Omnidirectional On;Off

HH1800 User Guide 79
Data Format 1
Data Format 2
Data Format 3
Single Scan Data Format Change
You can also switch between data formats for a single scan. The next barcode is scanned using
an alternate data format, then reverts to the format you have selected above (either Primary,
1, 2, or 3).
For example, you may have set your device to the data format you saved as Data Format 3.
You can switch to Data Format 1 for a single trigger pull by scanning the Single Scan-Data
Format 1 barcode below. The next barcode that is scanned uses Data Format 1, then reverts
back to Data Format 3.
Single Scan-Primary Data Format
Single Scan-Data Format 1
Single Scan-Data Format 2
Single Scan-Data Format 3