When using a USB interface, you may wish to configure your scanner to communicate with
Remote MasterMind Scanner Management Software (ReM). Scan the ReM On barcode to
communicate with ReM. To disable this capability, scan ReM Off. Default = ReM On.
If your interface is USB Keyboard or Keyboard Wedge, your keyboard layout default is a US
keyboard. To change this layout, scan the appropriate Keyboard Country barcode below. By
default, national character replacements are used for the following characters: # $ @ [ \ ] ^ ‘ {
| } ~. Refer to the "ISO 2022/ISO 646 Character Replacements" on page A-207 to view the
character replacements for each country.
To Next Page
Loading...
