Honeywell HH1800 - EZConfig for Scanning Introduction

116 HH1800 User Guide
EAN/JAN-8 Check Digit
This selection allows you to specify whether or not the check digit should be transmitted at
the end of the scanned data. Default = On.
* On
Off
EAN/JAN-8 Addenda
This selection adds 2 or 5 digits to the end of all scanned EAN/JAN-8 data.
Default = Off for both 2 Digit and 5 Digit Addenda.
2 Digit Addenda On
* 2 Digit Addenda Off
5 Digit Addenda On
* 5 Digit Addenda Off
EAN/JAN-8 Addenda Required
When Required is scanned, the scanner will only read EAN/JAN-8 barcodes that have
addenda. Default = Not Required.
Required