If you are encountering errors when reading Code 128 barcodes, you may want to adjust the
redundancy count. Redundancy adjusts the number of times a barcode is decoded before
transmission, which may reduce the number of errors. Note that the higher the redundancy
count, the longer it will take to decode the barcode. To adjust the redundancy, scan the Code
128 Redundancy barcode below, then scan a redundancy count between 0 and 10 on the
Programming Chart, beginning on page 211. Then scan the Save barcode. Default = 0.
Scan the barcodes below to change the message length. Refer to Message Length Description
(page 82) for additional information. Minimum and Maximum lengths = 0-80. Minimum
Default = 0, Maximum Default = 80.
To Next Page
Loading...
