Data Formatter On, Not Required,
Drop Prefix/Suffix
Data Format Required, Keep
Prefix/Suffix
Data Format Required, Drop
Prefix/Suffix
Data Format Non-Match Error Tone
When a barcode is encountered that doesn’t match your required data format, the scanner
normally generates an error tone. However, you may want to continue scanning barcodes
without hearing the error tone. If you scan the Data Format Non-Match Error Tone Off
barcode, data that doesn’t conform to your data format is not transmitted, and no error tone
will sound. If you wish to hear the error tone when a non-matching barcode is found, scan the
Data Format Non-Match Error Tone On barcode. Default = Data Format Non-Match Error
Tone On.
* Data Format Non-Match Error Tone
On
Data Format Non-Match Error Tone Off
Primary/Alternate Data Formats
You can save up to four data formats, and switch between these formats. Your primary data
format is saved under 0. Your other three formats are saved under 1, 2, and 3. To set your
device to use one of these formats, scan one of the barcodes below.
To Next Page
Loading...
