Honeywell HH1800 - UPC-A On;Off; UPC-A Check Digit; UPC-A Number System

HH1800 User Guide 101
UPC-A On/Off
* On
Off
Note:
To convert UPC-A barcodes to EAN-13, see Convert UPC-A to EAN-13 on page 108.
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted at the end
of the scanned data or not. Default = On.
* On
Off
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the
scanned data but can be programmed so it is not transmitted (Off). Default = On.
* On
Off