Honeywell HH1800 - Good Read Delay; User-Specified Good Read Delay; Trigger Modes; Manual Trigger

HH1800 User Guide 27
Good Read Delay
This sets the minimum amount of time before the scanner can read another barcode. Default
= 0 ms (No Delay).
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below, then set
the delay (from 0 - 30,000 milliseconds) by scanning digits from the Programming Chart,
beginning on page 211, then Save.
User-Specified Good Read Delay
Trigger Modes
Manual Trigger
When in manual trigger mode, the scanner scans until a barcode is read, or until the trigger is
released. Two modes are available, Normal and Enhanced. Normal mode offers good scan
speed and the longest working ranges (depth of field). Enhanced mode will give you the
highest possible scan speed but slightly less range than Normal mode. Enhanced mode is best
used when you require a very fast scan speed and don’t require a long working range. Default
= Manual Trigger- Normal.
* Manual Trigger - Normal
Manual Trigger - Enhanced