Honeywell HH1800 - UPC-E0 On;Off; UPC-E0 Expand; UPC-E0 Addenda Required

HH1800 User Guide 105
UPC-E0 On/Off
Most U.P.C. barcodes lead with the 0 number system. To read these codes, use the UPC-E0
On selection. If you need to read codes that lead with the 1 number system, use UPC-E1 (page
106). Default = On.
* UPC-E0 On
UPC-E0 Off
UPC-E0 Expand
UPC-E Expand expands the UPC-E code to the 12 digit, UPC-A format.
Default = Off.
On
* Off
UPC-E0 Addenda Required
When Required is scanned, the scanner will only read UPC-E barcodes that have addenda.
Default = Not Required.
Required
* Not Required