Honeywell HH1800 - RS232 Receiver Time-Out; RS232 Handshake

20 HH1800 User Guide
7 Data, 1 Stop, Parity None
7 Data, 1 Stop, Parity Odd
7 Data, 2 Stop, Parity Even
7 Data, 2 Stop, Parity None
7 Data, 2 Stop, Parity Odd
8 Data, 1 Stop, Parity Even
* 8 Data, 1 Stop, Parity None
8 Data, 1 Stop, Parity Odd
8 Data, 1 Stop, Parity Mark
RS232 Receiver Time-Out
The unit stays awake to receive data until the RS232 Receiver Time-Out expires. A manual or
serial trigger resets the time-out. When an RS232 receiver is sleeping, a character may be sent
to wake up the receiver and reset the time-out. A transaction on the CTS line will also wake
up the receiver. The receiver takes 300 milliseconds to completely come up. Change the
RS232 receiver time-out by scanning the barcode below, then scanning digits from the
Programming Chart, beginning on page 313, then scanning Save. The range is 0 to 300
seconds. Default = 0 seconds (no time-out - always on).
RS232 Receiver Time-Out
RS232 Handshake
RS232 Handshaking allows control of data transmission from the scanner using software