Honeywell HH1800 - Data Matrix; Data Matrix On;Off

92 HH1800 User Guide
appended data when it reads a Code 93 barcode that starts with a character other than a
space. Default = Off.
On
* Off
Code 93 Code Page
Code pages define the mapping of character codes to characters. If the data received does not
display with the proper characters, it may be because the barcode being scanned was created
using a code page that is different from the one the host program is expecting. If this is the
case, scan the barcode below, select the code page with which the barcodes were created
(see ISO 2022/ISO 646 Character Replacements on page 208), and scan the value and the Save
barcode from the Programming Chart, beginning on page 211. The data characters should
then appear properly.
Code 93 Code Page
Straight 2 of 5 Industrial (three-bar start/stop)
<Default All Straight 2 of 5 Industrial Settings>
Straight 2 of 5 Industrial On/Off
*On
Off