Scan the barcodes below to change the message length. Refer to Message Length Description
(page 82) for additional information. Minimum and Maximum lengths = 1-48. Minimum
Default = 4, Maximum Default = 48.
If you are encountering errors when reading Straight 2 of 5 IATA barcodes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a barcode is decoded
before transmission, which may reduce the number of errors. Note that the higher the
redundancy count, the longer it will take to decode the barcode. To adjust the redundancy,
scan the Straight 2 of 5 IATA Redundancy barcode below, then scan a redundancy count
between 0 and 10 on the Programming Chart, beginning on page 211. Then scan the Save
barcode. Default = 0.
To Next Page
Loading...
