You can set a time during which the scanner looks for an addenda. If an addenda is not found
within this time period, the data can be either transmitted or discarded, based on the setting
you are using for UPC-E0 Addenda Required. Set the length (in milliseconds) for this timeout
by scanning the barcode below, then setting the timeout (from 0-120 milliseconds) by
scanning digits from the Programming Chart, beginning on page 211 of this manual, then
Save. Default = 120.
When this feature is On, there is a space between the data from the barcode and the data
from the addenda. When turned Off, there is no space. Default = On.
Check Digit specifies whether the check digit should be transmitted at the end of the scanned
data or not. Default = On.
To Next Page
Loading...
