10
USE & OPERATION (CONTINUED)
EN
TEMPERATURE CONTROLS
Used for adjusting the thermostat.
The default display is room temperature.
In cooling mode, when + or - button is pressed, the set temperature is displayed and may be
adjusted. After a few seconds the display will revert back to room temperature. Temperature is
only adjustable in cool or heating mode.
•
•
•
FUNCTION BUTTONS (CONTINUED)
MODE CONTROL
Settings: Air Conditioning, Dehumidifying, Fan.
The corresponding indicator light will illuminate to indicate the current mode setting.
Air Conditioning Mode (COOL)
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 61°F - 89°F (16°C - 32°C).
•
Dehumidifying Mode (DRY)
Air is dehumidified as it passes through the unit without being in full Cooling mode.
If room temperature is higher than 77°F (25°C), fan speed can be adjusted. Otherwise, fan speed
is preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose.
Continuous drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
•
Fan Mode
For air circulation without air conditioner cooling.
•
Note: By pressing both + or - buttons at the same time, the display will toggle between Fahrenheit (°F)
and Celsius (°C).
4 settings: Auto , Low , Medium , and High .
Auto Fan
Press the + or - button to select the temperature you want. Press the Mode button to select
cooling or heating mode. After you press fan button and select Auto Fan , the unit will
automatically run its fan speed depending on the temperature difference between the set & room
temperature.
Note: Auto: This function can be selected under cooling mode only.
FAN SPEED CONTROL
To Next Page
Loading...
Need help?
General
