IHR810 User Manual
www.impactbyhoneywell.com
16.
（1）： Select a serial port or USB port
（2）： Select a printer type
（3）： Choose HEX
（4）： Input command code to change the IP in the printing content box: 1F1B1F91004950C0A81364, this is the IP address,
as shown in the above picture, IP address is 192.168.19.100, and the corresponding hexadecimal is C0A81364.
（5）： Finally click "print" button, and the printer will beep once, it suggests the
command has been sent successfully. Finally, self check the printer again to see if the IP address has been modified.
III. Make configuration by browsing the WEB
Second method to change the IP address is through the WEB. The specific
Method is as follows:
1. Make the computer IP address and the printer IP address get into the same net work segment as described in details above.
2. Open your browser; enter the IP address of the printer in the address bar, for example, the current printer IP is
192.168.123.100, as shown in the picture below
1
2
3
（1）： Click“Configuration”button.
（2）： Input the IP address, subnet mask and gateway address you want to set respectively in the three lines
（3）： Click the "Save" button to save the related Setting information
Note: That only the printers and computer within the same network segment are allowed to enter the WEB configuration
interface.
To Next Page
Loading...
