IHR810 User Manual
www.impactbyhoneywell.com
15.
2. Reopen the IMPACT IHR810 Utility software again, click "refresh" button to update the local IP address, then click the
"connection test" button , after the prompt window indicating the successful connection appears, click the "set up IP" to
modify the printer IP address. Please refer to the picture below:
3. Printing the Self test again to see if IP address has been modified successfully:
The above self test page shows that the new IP address has been set successfully. This method is suitable for all Ethernet
port printers.
II. Make configuration by sending the command codes
There are two other modification methods, the first method is as follows:
1. Connect the printer to the computer through the serial port, USB port and the Ethernet port, then test the USB or serial
port for normal communication, if the test is OK, send command via a serial port or USB port to modify the Ethernet port
IP (Command:1F1B1F91004950ip1~ip4). Please refer to the following picture
To Next Page
Loading...
