- 4 -
Range:
DT-640STC 12 m x 12 m
(40' x 40')
DT-660STC 18 m x 18 m
(60' x 60')
DT-6100STC 30.5 m x 6 m
(100' x 20')
Alarm relay:
Energized Form C (NC)
125 mA, 25 VDC
22 ohm series protection resistor
PRODUCT SPECIFICATIONS
PIR fields-of-view:
standard (wide angle) lens
44 long range
12 intermediate
6 lower
4 down
IMPORTANT: The DT-600 series sensors should be tested at least once
each year to ensure proper operation.
Power requirements:
10 - 12.9 VDC
35 mA max., 12 VDC
PIR white light immunity:
10,000 Lux
RFI immunity:
10 MHz - 1000 MHz (30 V/m)
Trouble output:
Open collector
Voltage between collector and
emitter (Vce) is .3V max at 50 mA
1K series protection resistor
(for future use)
Command input:
Self-test initiate
Active low 0 to 1.5V
Inactive high 6 to V+
Input impedance 110 Kohms
(min.)
Sensitivity:
2 - 4 steps within field of view
Copyright 2001 IntelliSense.
All Rights Reserved.
5-051-512-00 Rev B
IntelliSense, DUAL TEC, and INFORMER are
registered trademarks of Honeywell, Inc.
Frequencies:
Varies per country
Tamper:
NC, 25 mA, 30 VDC
Operating temperature:
0
o
to 49
o
C (32
o
to 120
o
F)
Dimensions:
13 cm x 7 cm x 6 cm
5" H x 2-7/8" W x 2-5/16" D
Weight:
340.2 g (12 oz )
Accessories:
SMB-10 swivel mount bracket
Lens Kit P/N 0-000-400-05
*NOTE: The ULC label or listed marking on a product is the only
evidence provided by Underwriters Laboratories of Canada to identify
products that have been produced under the Listing and Follow-up
Service.
2.3 m
(7'6")
12 m (40' )
Down
Long Range
Intermediate
Zones
floor
Lower
SIDE VIEW
Wide Angle Lens
SIDE VIEW
Barrier Lens
floor
2.3 m
(7'6")
30.5 m (100' )
DETECTION PATTERNS Patterns for: DT-640STC
(Use as reference for DT-660STC)
DT-6100STC Pattern
12 m (40')
TOP VIEW
Wide Angle Lens/Pet-Alley
SIDE VIEW
Barrier Lens
floor
2.3 m
(7'6")
12 m (40' )
TOP VIEW
Barrier Lens
DETECTION PATTERNS FOR OPTIONAL LENSES
SIDE VIEW
Pet-Alley Lens
1.2 m (4')
IMPORTANT: For UL certificated installation, the DT-600 series sensors
must be connected to a UL listed power supply or UL listed control unit
capable of providing a minimum of four hours of standby power.
Approvals/listings:
FCC certified
UL listed
ULC* listed
IC certified
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur
le matériel brouilleur du Canada.
12 m (40' )
12 m (40' )
Relative humidity:
5% to 95% relative humidity
(non-condensing)
NOTE: Pet-Alley lenses are not to be used in ULC-certified installations.
FCC Notice: This equipment has been tested and found to comply with the limits for a field
disturbance sensor, pursuant to Part 15 of the FCC Rules. The user is cautioned that changes or
modifications not expressly approved by IntelliSense could void the user's authority to operate
this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
To Previous Page
Loading...
