JADE™ ECONOMIZER MODULE
15 63-2700—05
SYSTEM
SETUP
INSTALL 01/01/11 Display order = MM/DD/YY
Setting order = DD, MM, then YY.
UNITS DEG ºF ºF or ºC Sets economizer controller in degrees Fahrenheit or Celsius.
EQUIPMENT CONV CONV
HP
CONV = conventional.
HP O/B = Enables Heat Pump mode. Use AUX2 I for Heat Pump input from
thermostat or controller.
AUX2 I n/a Shutdown (SD)
Heat (W1)
HP(O)
HP(B)
In CONV mode:
SD = Enables configuration of shutdown (default);
W = Informs controller that system is in heating mode.
NOTE: If using 2-speed fan mode, you must program CONV
mode for W. Shutdown is not available in the two-
speed fan mode.
In HP O/B mode:
HP(O) = energize heat pump on Cool (default);
HP(B) = energize heat pump on Heat.
FAN TYPE 1 speed 1 speed/
2 speed
Sets economizer controller for operation of 1 speed or 2 speed supply fan
NOTE: 2-speed fan option also needs Heat (W1) pro-
grammed in AUX 2 In.
FAN CFM 5000cfm 100 to 15000
cfm;
increment by
100
This is the capacity of the RTU. The value is found on the label from the
RTU manufacturer.
AUX1 OUT NONE NONE
ERV
EXH2
SYS
• NONE = not configured (output is not used)
• ERV= Energy Recovery Ventilator
d
• EXH2 = second damper position relay closure for second exhaust fan.
• SYS = use output as an alarm signal
OCC INPUT INPUT or
ALWAYS
When using a setback thermostat with occupancy out (24 Vac), the 24 Vac
is input “INPUT” to the OCC terminal. If no occupancy output from the
thermostat then change program to “ALWAYS” OR ad a jumper from
terminal R to OCC terminal.
FACTORY
DEFAULT
NO NO or YES Resets all set points to factory defaults when set to YES. LCD will briefly
flash YES and change to NO but all parameters will change to factory
default values.
Table 5. Menu Structure
a
. (Continued)
Menu Parameter
Parameter
Default
Value
Parameter
Range and
Increment
b
Notes
To Next Page
Loading...
