Honeywell L5200 Series Installation And Setup Guide

LYNX Touch Installation and Setup Guide
- 34 -
Programming the Control
Program the Z-Wave Module
The following system options are programmed in this section:
Option Function
Z-Wave Enables or disables the Z-Wave Module
Temperature Display Toggles between Fahrenheit and Celsius (for Z-Wave compatible Thermostats)
Note: If applicable, preprogrammed defaults for the L5200/L7000 Control are shown on the screen unless otherwise noted.
SCREEN ACTION
5100-100-067-V0
Z - Wave
1. Enter Program Mode and default the panel (Refer to “Loading Factory Defaults”).
2. Select “Z-Wave”
The System displays the following options:
Z-Wave
Temperature Display
Z-Wave
Enabled-Installed Telephone
3. Select “Z-Wave”. The system toggles between the following options:
Enabled – Installed Telephone Side
Disabled
Select “Enabled – Installed Telephone Side”.
Temperature Display
Fahrenheit
4. If you wish to change the temperature format, select “Temperature Display”. The
system toggles between the following options:
Fahrenheit
Celsius
5. Select “Save”.
6. Select the “” key to return to the previous screen or the Home button to return to
the Home screen.
7. Include Z-Wave devices. (Refer to Including/Excluding Z-Wave Devices in the Home
Automation Guide P/N 800-16091 or higher.)

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English