Honeywell L5200 Series Installation And Setup Guide

LYNX Touch Installation and Setup Guide
- 37 -
Programming the Control
Program Zones (Continued)
Supervision
Supervised
Supervision
The system displays the applicable Supervision options based upon the Device Type that was
selected. Select “Supervision” to scroll between the following options:
Hardwire Zone
Normal Open
Normal Closed
End of Line
RF Zone
Supervised
Unsupervised
Temperature (Defaulted for Zones 180-187)
Note: Zone 186 and 187 are only available on the L7000)
High Temp (Default selection for Zones 180, 182, 184 and 186)
Low Temp (Default selection for Zones 181, 183, 185 and 187)
After making a Supervision selection, select “Save”.
Arm Night
No
Arm Night
If “Motion Sensor” is selected in the Response Type Field, the Arm Night option will be
available. Use the down  arrow to scroll to the next page of options.
Select “Arm Night” to toggle between “No” or “Yes”. Select “Save”.

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English