- 14 -
✻
✻✻
✻56 ENHANCED ZONE PROGRAMMING WORKSHEET
Button Zones
Zone No. Zone Alarm Report Input Loop Transmitter Vocabulary
(A 01) Type (zt) Code in hex (rc) Type (i) No. (l) Serial Number Index
2|6
| [21] | | [01 00] [5] [3 | |
2|7 | [22] | | [01 00] [5] [2] | |
2|8 | [20] | | [01 00] [5] [4] | |
2|9 | [23] | | [00 00] [5] [1] | |
3|0 | [21] | | [01 00] [5] [3] | |
3|1 | [22] | | [01 00] [5] [2] | |
3|2 | [20] | | [01 00] [5] [4] | |
3|3 | [23] | | [00 00] [5] [1] | |
3|4 | | | | |
3|5 | | | | |
3|6 | | | | |
3|7 | | | | |
3|8 | | | | |
3|9 | | | | |
4|0 | | | | |
4|1 | | | | |
EXPLANATION OF ZONE ASSIGNMENT TABLE HEADINGS
A 01 = ZONE No. Zone Numbers are 01 (wired), 02-25 (RF) only, 26-41 (Button) only, 92 (duress), 95, 96, 99 (panic)
zt = ZONE TYPE
00 = Not Used
01 = Entry/Exit #1
02 = Entry/Exit #2
03 = Perimeter
04 = Interior Follower
05 = Trouble Day/Alarm Night
06 = 24 Hr Silent
07 = 24 Hr Audible
08 = 24 Hr Aux
09 = Fire without Verification
10 = Interior with Delay
14 = Carbon Monoxide
20 = Arm–Stay
21 = Arm–Away
22 = Disarm
23 = No Alarm Response
24 = Silent Burglary
rc = ALARM REPORT CODE Two Hex Digits. For each Hex Digit, enter: 00–09 for 0–9, 10 for A, 11 for B,12
for C, 13 for D, 14 for E, 15 for F. If "00" is entered as the first digit, there will be
no report for that zone.
For Contact ID reporting, this is enabling code only. Enter any hex digit (other
than 00) in the first pair of boxes. The second pair of boxes is ignored.
i = INPUT TYPE Enter 3 for RF: Supervised RF
Enter 4 for UR: Unsupervised RF
Enter 5 for BR: Button Type RF
l = LOOP NUMBER Used with 5800 RF Loop Input Devices. Record transmitter loop number. Entries
are 1-4, depending on device being used. Refer to the transmitter’s instructions for
appropriate loop numbers.
Zones 2-25 should be assigned as Input Type 3 or 4
and Zones 26-41 should be assigned as Type 5 only.
To Next Page
Loading...
