-20-
✻
✻✻
✻85 RECORD CUSTOM VOICE DESCRIPTORS
Use this mode to record up to 5 custom voice descriptors for use with zone announcements. Press ✻85 while in
programming mode.
NOTE: Entry of a number other than one specified will give unpredictable results.
85
8585
85
REC
REC REC
REC
VOICE
VOICE VOICE
VOICE
DESCR
DESCRDESCR
DESCR
Record Custom Voice Descriptors
0 = Exit mode, upon which this prompt blinks.
1 = Enter mode
A
AA
A
CUSTOM
CUSTOM CUSTOM
CUSTOM
DESC
DESC DESC
DESC #
Custom Descriptor Number
Enter 7 + d + [✻]
where d = 0-4, each representing custom word 70, 71, 72, 73 or 74 respectively. Existing
descriptor will be announced.
Press [#] to start recorder. Begin speaking immediately after the third beep.
Speak the desired word clearly near the keypad microphone. Recording stops after 1.5
seconds.
6 = Accept word and ready to record next descriptor (prompt A….7d)
[#] = Re-record descriptor
00 = Exit Record mode after pressing 6 (displays blinking 85; enter ✻ + desired data field
or menu mode number)
Press any other key to repeat the recorded word.
To Next Page
Loading...
