Return to Table of Contents
• If problems are encountered when trying to enroll the WiFi module or if there is a problem in maintaining the
wireless connection with a router not found on this list, a Honeywell WAP-PLUS can be used in conjunction
with the existing router.
What to do if the L5100 wifi stops responding to the Customers Router.
If your customer is experiencing issues where the L5100 Wi-Fi stops responding to the router or if
the customer’s wireless router is reset and the L5100 Wi-Fi does not reconnect back to the
customer’s router.
• Reset the L5100 panel – see section below, How do you reset the L5100 without powering down the system?
• KEEP IN MIND THERE ARE MANY VARIABLES IN MAINTAINING A WIFI CONNECTION AND
WE SHOULD NOT NEGLECT BASIC TROUBLESHOOTING PROCEDURES, SUCH AS:.
1. Does the Wifi module have sufficient RSSI and is within the suggested range of the access point?
2. If the WAP-Plus is being used, did you ensure it is not potentially causing a conflict with the network
Access point?
3. Does the premise have reliable internet service? Are other WiFi peripherals having a problem maintaining
connection?
4. Could problem be due to the environment or from other things transmitting RF energy, ie, a microwave
oven?
Tablet
COBY KYROS MID-7h Tablet General Information
• Does not support programming modes (Master user screen, Installer program screens, and Advanced Z-wave
screens)
• Can be used with Tuxedo
• Can be learned in many panels (vacation and main home)
• App available on Getjar app store.
IPad, Iphone, Ipod touch General information.
• Does not support programming modes (Master user screen, Installer program screens, and Advanced Z-wave
screens)
• Can be used with Tuxedo
• Can be learned in many panels (vacation and main home)
When can a dealer install the MID-7H / Ipad, Iphone, Ipod touch?
If there is no CS monitoring?
• Yes, but they need to install a L5100-Wifi card or iLP5 and program it in the “Communicator” screen. Do not
enter any CS ID, City ID, or acct id information. In Reporter, ensure Communicator type is set to “None”.
To Next Page
Loading...
Need help?
General
