Return to Table of Contents
If Pots is the only desired CS reporting?
• Yes, but they need to install a L5100-Wifi card or iLP5, program it in the “Communicator” screen, Do not
enter any CS ID, City ID, or acct id information. In Reporter, ensure Communicator type is set to “None”.
But this time enter the phone information.
• Note – these two options above will work with or without Broadband being available!
Wifi/iP only reporting?
• Yes, they need to install a L5100-Wifi card or iLP5, program it in the “Communicator” screen, enter CS ID,
City ID, or acct id information. In Reporter, ensure Communicator type is set to Wifi or IP as appropriate.
• Note – Tablet stops working if either the Internet is down, or if Alarmnet is down (if the ping sent every 20
seconds is not acknowledged, the L5100 reboots the wifi card)
IP primary with GSM back up?
• No, you cannot put IP and GSM in the same unit
Wifi primary, GSM back up?
• Yes, but they need to install a L5100-Wifi card and GSM, program it in the “Communicator” screen, enter CS
ID, City ID, or ACCT ID information. In Reporter, ensure Communicator type is set to Wifi/GSM.
• Note: The tablet will stop working if AlarmNet is not accessible via the L5100-WiFi. When registered with
AlarmNet, L5100-WiFi will ping the AlarmNet server every 20 seconds. If the ping is unable to reach the
server, the L5100 will reboot the WiFi card. This will prevent the tablet from working during that time.
The tablet does not have Panic keys, how do I send Panic?
• Work around is:
• Use a 5802wxt panic
• Enter a Duress code for burg
Is the tablet Supervised?
• Yes. The L5100 supervises the Tablet every 15 seconds
Can the tablet work with the ILP5 IP communicator?
• Yes, it works with either ILP5 or L5100-WiFi, as long as you have a wireless router.
To Next Page
Loading...
