Honeywell LYNX User Manual

– 24 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Entry/Exit Delays
Entry/Exit DelaysEntry/Exit Delays
Entry/Exit Delays
system/zone status area. The alarm will continue to sound until the system is disarmed or
timeout ocurs. To stop the alarm, the system must be disarmed by selecting the “Disarm”
icon OR depressing the “Off” key and then entering your security code. The message “Alarm
Cancelled" is displayed, in the system bar, indicating that the alarm has been cancelled (if
this feature is enabled by the installer). “Alarm” and the faulted zone continue to be
displayed with their associated icons in the system/zone status area. To clear the display,
select the “Disarm” icon OR depress the “Off” key and then enter your security code a second
time. An exit alarm also results if an entry/exit door or interior zone is faulted within two
minutes after the end of the exit delay.
Entry Delay
Entry Delays give you time to disarm the system when you re-enter through the designated
entrance door. You must disarm the system before the entry delay period ends, or an alarm
will occur. The control beeps during the entry delay period, reminding you to disarm the
system. There are two entry delays (if programmed). The first is for your primary entrance
and the second can be used for a secondary entrance, where a longer delay is required to
walk to the control to disarm the system. You can also arm the system with no entry delay at
all by selecting the “Delay” icon prior to arming the system. This will toggle the system to
“Instant”, which can provide greater security while on the premises or while away for
extended periods of time. See ARMING THE SYSTEM section for procedure. See your
installer for delay times programmed for your system.
Exit Delay:
None, 30, 45, 60, 90 seconds, 2 minutes
Entry Delay 1:
None, 30, 45, 60, 90 seconds, 2 minutes
Entry Delay 2:
None, 30, 45, 60, 90 seconds, 2 minutes
LYNX Touch SIA Exit/Entry Delay Times
Exit Delay: 45, 60, 90 seconds, 2 minutes
Entry Delay 1: 30, 45, 60, 90 seconds, 2, 3, 4 minutes
Entry Delay 2: 30, 45, 60, 90 seconds, 2, 3, 4 minutes

Honeywell LYNX Specifications

General

Voice Control	No
Type	Wireless Security System
Voice Prompts	Yes
Display	Color touchscreen
Communication	Cellular
Automation	Z-Wave
Battery Backup	Yes
Series	LYNX Touch
Compatibility	Honeywell Total Connect
Power Supply	Plug-in transformer
Keypad	Integrated touchscreen
Remote Control	Via Honeywell Total Connect app